The Causes And Solutions Of Uneven Winding Of Stretch Film

In the process of production or use, there will inevitably be some problems, such as uneven winding of the product. Why does this happen? How do we deal with that?

1. Reasons for uneven collection:

(1) Static electricity causes the tension film to be attached to each other, which leads to the unsmoothness.

(2) The surface of the product just produced is not smooth enough or too smooth.

(3) improper tension setting or guide roller is not parallel.

2. Solution for incomplete collection:

(1) Take effective measures to eliminate the electrostatic influence during the winding of stretch film.

(2) If the product is not smooth, negotiate with the raw material supplier.

(3) Adjust tension and taper setting and check the parallelism of guide roller.

Therefore, before the production of stretch film, we should know more about the problems that will occur in this process, and then take preventive measures to reduce these problems. When using, we should also check the relevant matters for attention, so as to avoid problems when using.